I can use a browser with the IP just fine. #Opensprinkler ip update#I can provide more details if necessary, but has anyone else had this issue with the U-verse router? Anything I else should be doing? I’d appreciate any insight the community might have. Todays update broke all capability to connect to my open sprinkler. The WRT54g does not lose its IP but the OSPi does, it just no longer shows up as an active device on the 3801hgv. I have just updated my OpenSprinkler Pi to the most recent version, using the 'git pull' method, and am now running version 2.2.2 () which can be seen in the bottom right-hand corner of the login and main screens. The web interface is on port 8080 of your Raspberry Pis IP address. in the device IP address, you will see the OpenSprinkler web interface and. I have the auto reconnect set to yes on the OSPi and some Keep Alive settings turned on for the WRT54g. OpenSprinkler Pi (OSPi) is a sprinkler / irrigation extension board for Raspberry. OpenSprinkler is an open-source, web-based sprinkler/irrigation controller. The issue seems to be that after a day or two or three, the connection seems to drop. When I initially set this up, I can access the the OSPi from my local network and externally thanks to port forwarding. is the Raspberry Pis IP address (such as http://ospi-ip-address:8080. #Opensprinkler ip mac#When I go into the control panel for the 3801hgv, the OSPi originally shows up and I see the MAC Address.Īt this point I have tried two things, I let the router assign the IP address and told the router to assign it 192.168.1.150, I have also turned off DHCP on the OSPi and manually entered 192.168.1.150. OpenSprinkler Pi (OSPi) is an open-source sprinkler / irrigation extension. The issue I am having is that the router consistently retains its IP Address, but the OSPi seems to disappear. WRT54G with dd-wrt loaded and setup in bridge mode (IP address 192.168.1.2) (This box is not providing IP addresses, DHCP is done by the 3801hgv) U-Verse internet with Pace 2Wire 3801hgv main router (IP address 192.168.1.254)Ģ. The controller typically works just fine, but I am finding that I am losing an IP address after a day or two.ġ. Assign it to an area like your garage and click Finish. Next, add your OpenSprinkler IP address, login password, and controller name. ESP8266 does have a breakout board, I didn't have one available so I decided to solder it straight on some pins. Navigate to Configuration > Integrations > Add Integration. I recently purchased the pre-assembled OSPi with Firmware Version 2.0.4 and I love it. A few things about this build: - Voltage regulator - I didn't have a 3.3v voltage regulator that could work on 12v, I've had to get it down to 5v (with 7805) and then again to 3.3v (with A1117). I’m a new OSPi owner and first time poster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |